| Document |
Document Title |
|
JP55066739 |
PURPOSE: To detect and avoid the production of formed pieces with inferior mixing ratio by providing a sampling shoot with an automatic switching dumper at the intermediate portion of a main shoot connected to a hopper. CONSTITUTION: A m...
|
|
JP54158524 |
PURPOSE: To precisely measure an engine suction air volume at a wide scope, by using a heat type flow meter at a low suction air flow volume range of an engine and a venturi meter at a high suction air flow amount area. CONSTITUTION: A r...
|
|
JP54145166 |
PURPOSE: To achieve the improvement in the accuracy of flow rate measurement by supporting and fixing a temperature-dependent resistor on the substrate surface of inorganic insulation material and so constituting said substrate that it a...
|
|
JP52143858 |
PURPOSE: To improve the accuracy of air flow rate detecting under the state of Karman's vortex, by which the working range of the engine, through the introduction of a double venturi tube in the place of the regular type venturi tube whi...
|
|
JP52120860 |
PURPOSE: To detect the air-fuel ratio in the exhaust gases with the use of simple construction by embedding another electrode in the space between two opposed electrodes and by impressing a voltage between the embedded electrode and one ...
|
|
JP52073764 |
PURPOSE: Flow rates each phase in two-phase mixed liquid such as of hot water and steam are measured at accuracy of the extent effective in practical use by the combination use of an electrode type voids meter and a Pitot tube.
|
|
JP52038957 |
PURPOSE: To collect samples in proportion to flow rate in a pipe by using valves which open and close mutually whenever they receive signal of which frequency is proportional to flow rate in a main pipe, and utilizing the pressure in the...
|
|
JP52028384 |
PURPOSE: To reproduce an imaginary flow line corresponding to the flow rate of effluent water running in a flow thereby making possible the simple sampling of water from flow lines over a wide range and obtaining a water sampling apparat...
|
|
JP52026619 |
PURPOSE: To make plural number of liquids capable of mixing always at a constant mixing ratio even when the flow quantity is changes.
|
|
JP51140658 |
PURPOSE: To measure a real flow quantity with high accuracy by effecting compensation using a mix ratio as a parameter to a measured value of a mixed fluid.
|
|
JP51140758 |
PURPOSE: To measure each constituent flux of two kinds of liquid in succession and with high accuracy from the flux of mixed liquid consisting of two kinds of liquid.
|
