Technical problem Technical problem solving by this participation contains the solvation in producing electrical producing electrical energy in three phasic of alternant current at the frequency of the 50 Hz. Harnesing of energy is reduced (related to the mass of the generator and input of the energy (Nm)).

At the six phasic synchronous generator motor and transformator with the magnetic balance of the alternant current of the output frequency 50+100+300=450Hz x2900Hz, the harness of the energy is bigger: 5 (five) times more in relation to existing three phasic generator.

The excitation strenght is 50% lower than of the three phasic generator. By this device we are solving the problem of damaging generator'winding at the short circuit. The electrical power of the short circuit at the full loading is zero (0) and the result of mechanical energy is idle work.

/ Technical status On the first prototype during the testing in laboratories the following results are shown: 1. the frequency of generator=50-100 i 300 Hz 2. the shape of energy is shown on drawings (see scheme) 3. by connecting two generators in series (prototype of generator) the result is regular double sinuoside 4. fluo tubes work without coils and glowing thread, with the economizing of 500& as all and inductive resistance The description of technical problem soluation Six phasic sinchron motor generator and transformator with magnetic of alternative balance consists of stator and rotor.

- Stator Stator is winding six phasic in two tropole groups connected for each group into star with following marks: 1. The beginning of the coils: U-V-W-Ul-Vl-Wl 2. The end of the coils: X-Y-Z-Xl-Y1-Zl (see scheme) In each phasic there are doubled coils connected in the serie. Two tropole groups are devided by electricity. In every phasic the condensator is connected C=3, 75nF. The inducted electro-motor power is individually going on the first group U-V-W. It occupates one half of the stator or the circle of 180 degrees. Leaving the first group enters the second group Ul-Vl-Wl i. c. into another half of the stator of 180 degrees.

When the poles in one phasic are exactly under the double floor coil, the directions of the powers are opposite each other, because the direction of the revolution poles is equal.

The stator's magnetic field is rejected from the rotor's magnetic field. At this point generator works as the motor. Condensator gives the energy of the consumer and mechanical energy is in that case-0-Nm. When pole-S-or-N-leaves doublefloor coil and transveres into one half of the coil, then I. E. M. S. in half of the coil of each phasic with one pole equal in one half of the coil, then the condensators fulfill.

Magnetic coils of the half of the pole S and one of the half of the pole N in inner side of the pole closed while magnetic coil of the outer half of the pole S-S and the half of the pole N close the other circle around the half of the stator.

While the rotating of rotor rotates outer (stream of coils of the poles S and N) then it transformed E. M. S. in the half of the stator's coils with the frequency 50 Hz.

2x twice UF=278-V x 4 + (2,5769099 x 5)- (83. 446533: 100) x4) 2 =235V 5 5 C=3,75 nF x 6=22,5 nF N=391,83673 W - Rotor Rotor has two poles moving each other for 90% (see scheme) and winding with coils-CU-supporting by moving rings and graffit brushes for input of electricity, excitation and strenghts.

Rotor has protoweight of plumbum (Pb) because of the balance (see scheme of stator and rotor).